ETS-Lindgren SMART 1000 Mini-Reverb Cell - Manual (Page 12)

12 | Maintenance
Do not polish the brass or beryllium copper
finger stock with steel wool, electric sanders,
wire brushes, medium or fine sandpaper, or any
abrasive materials or devices other than those
specified in Maintenance on page 40.
Do not polish any of the brass striking surfaces
with any type of brass polish.
Do not apply a floor wax to the door sill of door
types D and E (flush sills). Use caution when
waxing the floors inside and outside the
enclosure to make sure that wax is not applied
to the flush door saddle.
Do not apply wax to the metal surfaces of the
chamber.
Do not attempt to oil hinges or door handles.
They are permanently lubricated.
M ONTHLY M AINTENANCE
To catch excess fluids, place absorbent material (cloth, sponge, and so on)
beneath the entire length of the door sill prior to cleaning and lubricating. Do not
wipe finger stock.
Perform proper cleaning and lubrication of the contact finger
mechanism every month.
Use the cleaning agent Channel Master 9101; lubricate only in accordance with
the manufacturer instructions.
1. Use a generous amount of the cleaning agent to flush the entire finger
recess on the door frame. Start across the top of the door frame and
work down both sides. Flush bottom last. This process will wash off all
visible residues on fingers.
2. Wipe brass door frame with a clean cloth.