EFCO Dorma RTS 88 - Manual (Page 5)

BAB 7/01
PAGE 3
A. BUTT HINGE, CONTINUOUS HINGE, AND CENTER PIVOTS
1. 1 3/4" OR 2" HEADER/T’BAR INSTALLATION STEPS
SECTION II HEADER/TRANSOM BAR INSTALLATION
A.
ATTACH THE DORMA "F" CLIP TO THE HEADER/TRANSOM BAR WITH TWO
#10-32x5/8" PL-FH-MS.
B.
PLACE TWO 1/4-20x1" PL-FH-MS THROUGH THE HOLES IN THE HEADER/T-BAR
AND SECURE THEM WITH TWO 1/4"-20 HEX NUTS AND LOCK WASHERS. PLACE THE
ANGLE BRACKET ON THE THREADS THAT EXTEND PAST THE NUTS AND SECURE
WITH TWO MORE 1 /4"-20 HEX NUTS AND LOCK WASHERS.
C.
APPLICATIONS WITH A 2" HEADER/T-BAR:
ONE SPACER BLOCK {F045} MUST BE USED BETWEEN THE "F" CLIP AND THE
HEADER/T-BAR. USE TWO #10-32x5/8" PL-FH-MS TO FASTEN THE ASSEMBLY INTO
PLACE.
D.
APPLICATIONS WITH A 2" HDR/T-BAR:
USE TWO 1/4-20x1" PL-FH-MS THROUGH THE HOLES IN THE HEADER/T-BAR TO
SECURE ONE SPACER BLOCK {F045} WITH TWO 1/4"-20 HEX NUTS AND LOCK
WASHERS. PLACE THE ANGLE BRACKET ON THE THREADS THAT EXTEND PAST
THE NUTS AND SECURE WITH TWO MORE 1/4"-20 HEX NUTS AND LOCK WASHERS.
E.
COAT BOTH ENDS OF THE HDR/T-BAR WITH BUTYL TYPE SEALANT AND FASTEN
THE "F" CLIP(S) TO THE HINGE/PIVOT JAMB(S) WITH THREE #8-32x5/8" PL-PH-MS
EACH.
F.
AT SINGLE DOORS LOCATE THE HDR/T-BAR ON THE SHEAR BLOCK {K120} AT
THE LOCK JAMB AND FASTEN INTO PLACE WITH SUPPLIED SCREWS.
THE BUTT HINGE AND GEARED HINGE APPLICATION HEADER PREPS ARE IDENTICAL.
THE CENTER PIVOT AND OFFSET PIVOT APPLICATION HEADER PREP ARE NOT, DUE
TO THE DIFFERING CLOSER LOCATIONS. THE BUTT HINGE, GEARED HINGE, AND
CENTER PIVOT INSTALLATION PROCESS IS IDENTICAL. PLEASE FOLLOW THE
CORRECT INSTRUCTIONS FOR YOUR C.O.C. APPLICATION.