Exterior, Fig. #34, Door jamb assembly – EFCO 406 (T) Series User Manual

Page 32: D - screw spline frame & side lite to

DOOR JAMB ASSEMBLY

SECTION IV ASSEMBLY & INSTALLATION

D - SCREW SPLINE FRAME & SIDE LITE TO

NOTE: THE SILL FLASHING ENDS AT A DOOR JAMB.

THE SILL FLASHING RUNS THRU AT JAMBS

NOTE: Use full lengths of LB78 perimeter adaptor at the head and jambs as a caulk backer

and to keep from collapsing the glazing pocket. Use 3" lengths of LB78 perimeter adaptor

(FV16) at the sill member and locate them at the fastener, to keep the anchors or weight of

the glazing material from collapsing the glazing pocket.

SILL FLASHING

AND VERTICAL INTERMEDIATES.

NOT SHOWN

#9357/#9358 SIMILAR

#8401 HORIZ. SHOWN

#9359 HEAD

#9357 SILL

#9359 JAMB
NOT SHOWN
FOR CLARITY

FIG. #34

WAX ALL SCREWS

S129

ASSEMBLY SCREWS

HORIZONTALS BEFORE

THE ENDS OF ALL

APPLY SEALANT TO

ASSEMBLY.

DOOR JAMB

APPLY SEALANT TO

SNAP AREA AT THE

WAX ALL SCREWS

INTERIOR AND
EXTERIOR.

S129

#9358 SHOWN at

PAGE 30

LB78/FV16 PERIMETER
FILLERS NOT SHOWN
FOR CLARITY.
(REQUIRED @ HEAD, JAMB
& SILL)