View of jamb at condition, Fig. #29, K980 – EFCO 406 (T) Series User Manual

Page 29: Step 3)

INCREASE IN THICKNESS, IF THE CONDITION IN IRREGULAR.

INSTALLATION. THIS MAY CAUSE THE CAULK JOINT AT THE JAMB TO

CONCEALED WITH THE SEALANT TO PRESENT A NEAT CLEAN

AND THE PERIMETER SEALS. THE END CAP EDGES MUST ALSO BE

CONDITION AND THE SEALANT MUST TIE-IN WITH THE JAMB BLOCKING

THE SEALING PROCEDURE. THE END CAPS MUST BE SEALED TO THE

INCORPORATING THE SILL FLASHING END CAPS WILL COMPLEMENT

C - SILL FLASHING INSTALLATION

SECTION IV ASSEMBLY & INSTALLATION

The sill flashing must be sealed to the condition

and the jamb member set in a bead of sealant

to ensure a water tight seal.

OR LB78/FV16 VINYL NOT SHOWN

#9358 CONTINUOUS SHOWN

FIG. #29

VIEW OF JAMB AT CONDITION

#9357

STEP 3)

#9359

SEALANT

K980

(CONT.)

406 STOREFRONT

DPS 12/2002

PAGE 27