Fig. #28, Step 2) – EFCO 406 (T) Series User Manual

Page 28

WATER ONTO THE SILL FLASHING. SEE FIGURE BELOW.

WITH SEALANT LEVEL WITH THE SILL FLASHING TO DIVERT ANY

THOROUGHLY. FILL THE HOLLOW AREA OF THE DOOR JAMB

THE END OF THE SILL FLASHING TO THE DOOR JAMB

BEAD OF SEALANT THAT THE THRESHOLD IS SET INTO. SEAL

THAT FILLS THE CAVITY IN THE DOOR JAMB AND TIES INTO THE

FRAME. THE BEAD OF SEALANT WILL TIE INTO THE SEALANT

SEALANT BETWEEN THE MASONRY JAMB AND THE DOOR

INSTALL THE SILL FLASHING IN A CONTINUOUS BEAD OF

SECTION IV ASSEMBLY & INSTALLATION

C - SILL FLASHING INSTALLATION

FIG. #28

OPTIONAL SEALANT

SEAL OVER THERMAL STRUT

OF SEALANT TO THE

MASONRY JAMB

SEAL FLASHING

CONTINUOUS BEAD

APPLY SEALANT JUST

BEFORE SETTING THE

SILL MEMBER

TO JAMB

STEP 2)

Fill this cavity with

sealant, level with the

SEAL THIS AREA OF THE

sill flashing.

SILL FLASHING

(CONT.)

/200

PAGE 26