Drill guide for transom, Rew applied glazing, B - shear blocks at screw – EFCO 406 (T) Series User Manual
Page 11: Fig. #4, For transom - head and horizontal, Intermediate shear block application, 2) dj16 drill guide
TOP OF HORIZONTAL
FIG. #4
2"
TO FINISHED FLOOR
B - SHEAR BLOCKS AT SCREW
FOR TRANSOM - HEAD AND HORIZONTAL
(4) holes are located
# 26 Drill (.147 dia.),
determine the correct holes
horizontal (#8401).
to drill for the application
extrusion being used to
Refer to the horizontal
at head (#9359) or intermediate
per horizontal end.
INTERMEDIATE SHEAR BLOCK APPLICATION
block attachment holes as
pocket, then drill the shear
Insert this lug into the glazing
2) DJ16 DRILL GUIDE
F406
for left and right positions.
NOTE: The drill jig is reversible
TYPICAL VERTICAL MEMBER
2"
SECTION III FABRICATION
SPLINE DOOR JAMB
blocks.
hole pattern for the shear
drill guide to locate the
Use the top edge of the
indicated.
(CONT.)
PAGE 9
DPS 12/2002
406 STOREFRONT
See also other documents in the category EFCO For Home:
- Windows Hung General Maintenance Instructions (19 pages)
- Windows Hung Understanding Condensation (6 pages)
- Windows Hung Installation (58 pages)
- E-Lite (19 pages)
- E-Shade (41 pages)
- 2 1/2" Center Tongue Sun Shade Clip (19 pages)
- S5500 Advanced (46 pages)
- S5500 Inside Glazed (48 pages)
- S5500 Outside Glazed (48 pages)
- S5500 Router & Jig (6 pages)
- S5500 SSG Captured (81 pages)
- S5500 SSG (53 pages)
- S5600 Concealed Vent (13 pages)
- S5600 Inside Glazed (29 pages)
- S5600 Outside Glazed (26 pages)
- S5600 Slope Glazed (23 pages)
- S5600 Structural Glazed (28 pages)
- S5900 Inside Glazed (18 pages)
- S5900 Outside Glazed (16 pages)
- S5900 Structural Glazed (23 pages)
- 5500X Outside Glazed (60 pages)
- Duracast Pressure Plate (12 pages)
- 5800 Series (20 pages)
- 8700 Series Assembly Instructions Vol.1 (35 pages)
- 8700 Series Assembly Instructions Vol.2 (34 pages)
- 8700 Series Assembly Instructions Vol.3 (28 pages)
- 8700 Series Assembly Instructions Vol.4 (44 pages)
- 8700 Series Assembly Instructions Vol.5 (89 pages)
- 8700 Series Assembly Instructions Vol.6 (16 pages)
- 8700 Installation Instructions (68 pages)
- 8750XD (43 pages)
- 875X Wall Vent (31 pages)
- 401 Series Roto Vent for Storefront (14 pages)
- 401 Series Storefront (94 pages)
- 433 Series (90 pages)
- 525 Series (45 pages)
- 526 Series (50 pages)
- 960 Series (65 pages)
- WV410 (21 pages)
- 403X Series (29 pages)
- 406X Series (25 pages)
- 945 Series (50 pages)
- 955 Series (45 pages)
- 901 Series (52 pages)