Detex WSV Trim - Manual (Page 4)

OUTSIDE DOOR FACE:
9. Place back plate on door (use as template).
10. Center the back plate on pilot hole "e" and align back plate vertically.
11. Mark the cam center "d". Mark and center punch the other hole "e".
12. Make a new mark 1/4" higher than the cam center (just marked). This will be the mark for
the 1 3/4" outside cylinder hole "f".
13. Drill a pilot hole through the door for "e" and "f".
NOTE: DRILL STRAIGHT AND LEVEL
14. Using a 1 3/4" hole saw, cut through outside door face at "f".
NOTE: USE EXTREME CAUTION WHEN DRILLING 1 3/4" HOLE.
TIGHT TOLERANCE, NO MARGIN FOR ERROR.
INSIDE DOOR FACE:
15. Drill 3/4" hole through inside door face at "d".
16. Using a 5/16" drill bit, enlarge the two holes "e" through door.
17. See Fig. T6. Drill back plate mounting holes "a" per chart. CAUTION: Holes "a" are
drilled inside only.
Go to Instructions P/N 101257 (03WS Installation Instructions)
Complete Page 2 "Preparing the Trim".
Skip Page 3
Complete Page 4 "Assembling the Outside Trim....."
Resume with Panic Hardware Instruction #15.
INS-101269 PAGE 4
Backplate Mounting Holes “a”
1/4-20 Machine #14 Wood #14 Sheet 1/4-20 Machine Door Screw Length
Screw Screw Metal Screw Screws Thickness 1/4-20
Trim Holes “e”
# 7 3/16” # 7 5/16 1 3/8” 2”
OR
OR
1 3/4” 2 1/4”
13/64
13/64
1/4-20 2” or 2 1/4” * 3”
* Cut to length
Fig. T6