Detex 01W Trim User Manual
Page 2
DETEX INS-101272 Page 2
PREPARING THE DOOR:
1. Center punch hole “a” marked earlier.
2. Drill four (4) pilot holes “a”.
Caution: Be sure to drill STRAIGHT through the door.
3. Drill four (4) 3/8” holes partway through the door. Complete these holes by drilling from the op-
posite door face.
ASSEMBLING THE OUTSIDE TRIM AND BACKPLATE:
1. Align the four sex nuts and trim assembly through the drilled holes (Fig. T1).
2. It may be necessary to hammer the sex nuts into the door face.
3. Fasten the backplate to the inside door face with 1/4-20 machine screws provided.
Caution:
Do not overtighten.
4. Resume with panic hardware instruction #15.
Fig. T1
See also other documents in the category Detex Safety:
- 02D Trim (3 pages)
- 08D Trim (5 pages)
- 02W Trim (4 pages)
- C Trim (6 pages)
- 08DM Trim (2 pages)
- 02DM Trim (2 pages)
- 01WM Trim (2 pages)
- 01CM Trim (2 pages)
- 08DN Trim (5 pages)
- 03R Trim for 60 Series (3 pages)
- 02WP Trim (2 pages)
- WSV Trim (4 pages)
- Exit Alarm (7 pages)
- Electric Signal Switching (1 page)
- Electric Integration (1 page)
- Delayed Egress With Magnetic Lock (7 pages)
- Delayed Egress With Magnetic Lock (16 pages)
- V40 Series Alarmed Rim Exit Devices (16 pages)
- 01P Trim (2 pages)
- 02A Trim (4 pages)
- BN Trim (2 pages)
- V40 ED (13 pages)
- V40 EE (16 pages)
- V50 EE (23 pages)
- V40 EX (1 page)
- AO19-1 Push (10 pages)
- AO19-1 Pull (9 pages)
- AO19-2 Push (11 pages)
- AO19-2 Pull (10 pages)
- AO19-3 (12 pages)
- Keyed Removable Mullions (4 pages)
- ECL-600 (4 pages)
- EAX-3500FK (1 page)
- EAX-4200 (2 pages)
- DTX-2100 (8 pages)
- DTX-2300 (32 pages)
- DTX-4300 (112 pages)
- AT-5200 (2 pages)
- BE-961-1 (3 pages)
- VRA-143-B (10 pages)
- DDH-2250 (3 pages)
- CS-400 Momentary Models (2 pages)
- CS-400 Maintain Models (2 pages)
- DS-1481 (4 pages)