Salter Brecknell 7680 - Manual (Page 33)

Model 7600 Family PWC User’s Manual 33
M
Scale Response
xxxxxxxMM
hhh
Returns normalized
raw counts and
status
All other commands
Scale Response
?
Unrecognized
command
Contact your Weigh-Tronix service provider or
the Weigh-Tronix customer service department
for protocol.
Any system errors detected by the scale will be
displayed as the letter E followed by a two-digit
error code. Press the UNITS key to continue
operation. If a calibration error occurs, the only
way to clear it is by recalibrating the scale.
The error codes are broken down into two
hexadecimal numbers, with each bit defining a
single error condition. The error codes are
defined as follows:
Error Codes
NCI SMA, AS350D or
PS6L Communications
Protocol
Raw Counts