Salter Brecknell C3255 User Manual
Page 8
1000 Armstrong Drive. Fairmont, Minnesota 56031 Tel: 507-238-8702 Fax: 507-238-8271 e-mail:
For technical support contact us at 1-800- 458-7062 or fax us at 1-800-368-2042
Page 8 of 18
USING STORED CHECK WEIGHING TARGET SETTINGS
The Check weighing function can be used both in normal weighing mode and counting mode.
Under normal mode, it stands for weight. While in counting mode, it stands for quantity.
To use a stored check weighing target setting:
1. In normal weighing mode, press the desired numeric key and then press
CALL
key to enter into
check weighing mode. The scale will briefly show upper and lower check weights, for you to
validate the correct key has been chosen and activate the check weighing function. The following
is displayed if you press the
3
key, then
CALL.
2. Load weight on platform.
3. If loaded weight is in the setting weighing range, LCD will show
and the buzzer will
continually beep until the item is removed from the platform
.
4. If loaded weight under lower limit, LCD will show
to remind the operator the loaded
weight is not within the setting range. The low bar graph segment will change to indicate how
close you are to achieving the acceptable weight.
5. If loaded weight over upper limit, LCD will show
to remind the operator the loaded
weight is not within the setting range. The high bar graph segment will change to indicate how
close you are to achieving the acceptable weight.
To exit the check weighing mode, please press
0
key and then press
CALL
key or press the
MODE
key.
Note:
Under check weighing mode, press
CALL
key to call out the existed upper and lower check limit.