Salter Brecknell C3255 - Manual (Page 18)

1000 Armstrong Drive. Fairmont, Minnesota 56031 Tel: 507-238-8702 Fax: 507-238-8271 e-mail: [email protected]
For technical support contact us at 1-800- 458-7062 or fax us at 1-800-368-2042
Page 18 of 18
ERROR MESSAGES
1. Low Battery -
If this message is displayed, it indicates that
the battery needs to be replaced.
Solution: Replace the battery or plug in the
AC adaptor for operations.
2. Below Zero -
The scale senses a weight value that is less
than the allowable limit.
Solution: Re-power on the scale again. If
the message continues, the operator should
ask the maintenance men to check the
scale .
3. Over Zero -
This message indicates that operator have
too much weight on the scale when operator
turned the scale on.
Solution: Remove the excess weight from
the scale platform and turn the scale off and
then back on. If the scale continues to
display this message, call for service.
4. Overload -
If the weighting capacity exceeds the
maximum capacity of scale, the display will
show the right message.
Solution: Remove the weight from scale
platform right away.
5. Power on zero count over calibration zero
+10%.
Solution: Turn the scale off and then back
on.
6. Power on zero count under calibration zero -
10%.
Solution: Turn the scale off and then back
on.