Attwood Fold-Up Drink Holder Dual Ring - Manual

3
®
Attwood marine hardware, navigational lighting, bilge pumps, and other
marine accessories are specified more than any other brand by America’s
best-known boat manufacturers as original equipment. Look to Attwood
for quality replacement parts and marine accessories.
Form Number 69275 Rev. B 03-10
Drink Holder
Installation Instructions
© Attwood Corporation
1016 N. Monroe Street, Lowell, MI 49331-0260 www.attwoodmarine.com
Required for Installation
• Drill with 1/8" bit
• Four #10 stainless steel flathead screws (sold separately)
Figure 1
1.
Open the cover and flip both holder rings up.
2. Position the drink holder on the desired flat surface, holder
rings on top.
3. Using the four mounting holes as a template, mark pilot holes.
4. Drill four pilot holes.
5. Attach drink holder with four #10 stainless screws.
Figure 3
Flip small ring up, large ring down to hold 12 oz. can or small cup.
Figure 4
Flip large ring up, small ring down to hold beverage cooler, mug,
or large cup.
When not in use, flip both rings down and close cover.
A E
C F
B D
Figure 1
Both Holder Rings Up
Mounting
Holes (4)
•
•
•
#10 Stainless Steel
Flathead Screws
Cover Open •
Figure 2
Holder rings flip up and down individually for different
container sizes.
Figure 2
Small
Holder Ring
Large
Holder Ring
•
•
Figure 4 Figure 3
Dimensions
A. 4-9/16"
B. 4-5/8"
C. 3-1/16"
D. 1-7/8"
E. (Closed) 15/16"
F. (Open) 4-3/4"