Attwood Battery Straps User Manual

Battery strap boat floor, Battery box clamp installation instructions

6-3/4"

BATTERY BOX OUTSIDE WALLS

Battery Strap

Boat Floor

Screw Pilot
Center

Note: Match clamps in your
package with template for
corresponding hole locations.

CLAMP

INSTALLATION INSTRUCTIONS
1. Lay template on boat floor. Center clamps lengthwise on box so

they fit up into bottom groove.

2. Locate and mount clamps on flat surface of boat floor, using

template and screws provided. Figure 1

3. Route strap under clamp opening, making sure buckle is positioned

properly on top.

4. Place box over clamps so that lip on box bottom sits outside clamps.
5. After battery installation, buckle strap over cover per Figure 2.

CAUTION

Be sure battery box is in a properly vented compartment.

Figure 1

Battery Box Clamp
Installation Instructions

9065, 9067, 9069

Attwood marine hardware, navigational lighting, bilge pumps, and
other marine accessories are specified more than any other brand
by America’s best-known boat manufacturers as original equipment.
Look to Attwood for quality replacement parts and marine accessories.

SAVE THESE INSTRUCTIONS
Form Number 69336 Rev. C

03-10

Figure 2

Lace Between Teeth