Attwood Push/Pull Switch Three-Position - Manual

REQUIRED FOR INSTALLATION •
Drill with
³⁄₈
" (10mm) dia. bit
•
Slotted or phillips screwdriver
•
Pliers / or adjustable end wrench
•
Requires minimum 2" (50mm) clearance behind mounting panel after installation.
APPLICATION •
Install switch in dashboards or panels up to 1" (25mm) thick.
•
Rated load is 20 amps.
MOUNTING INSTRUCTIONS 1.
Bring power source wire and switched wires to panel. Attach wires to terminal screws. Figure 1
2.
Remove chrome handle and chrome nut from shaft.
3.
In desired location, drill
³⁄₈
" (10mm) dia. hole through panel. From
inside panel, insert shaft through hole.
4.
Tighten chrome nut and handle onto end of shaft. From inside, tighten brass nut and washer against panel.
Figure 1
3
®
Attwood marine hardware, navigational lighting, bilge pumps, and other marine accessories are specified more than any other brand by America’s best-known boat manufacturers as original equipment. Look to Attwood for quality replacement parts and marine accessories. SAVE THESE INSTRUCTIONS Form Number 69408 Rev. A
03-01
Three-P
osition Pull Switc
h
7594
Installation Instructions
© 2003 Attwood Corporation 1016 N. Monroe Street, Lowell, MI 49331-0260 www.attwoodmarine.com Chrome Handle
Chrome Nut
3/8" (10mm) Dia.
Brass Nut Brass Washer
Panel: 1" (25mm) Max
Terminal Screw Post #1 (Head)
Post #1-(ON) OFF
Basic Operation
Post #1-(ON)
1st Position: Accessory #1
2nd Position: Accessory #2
Post #2
(+)
(Bat.)
(+)
(-)
(+)
(-)
(+)
(-)
12V Battery
Fuse
Switched Wire
Switched Wire
Power Source
Wire