beautypg.com

Attwood Fold Up Trailer Jacks User Manual

Swivel-tongue screw jack, Warnings, Recommended location

background image

This Attwood Swivel-Tongue Screw Jack requires assembly
before use. Please read these instructions carefully.

WARNINGS:

• DO NOT exceed rated load capacity (1,000 pounds, 450Kg).
• Inspect retainer ring before each use. Ring must be

completely seated in the groove.

• When raising and lowering jack, keep body and feet clear of

trailer tongue.

• Jack must be secured in fold-up position before towing.

RECOMMENDED LOCATION

Locate jack so that:
• Handle clears obstructions when cranking
• Jack is clear to fold up.

ASSEMBLE WHEEL (Figure 1)

1. Insert bushing through wheel.
2. Insert wheel into the wheel fork.
3. Insert 3" (76mm) bolt through bushing and wheel. Thread on

nylock nut securely but leave enough slack so wheel spins freely.

INSTALLATION INSTRUCTIONS (Figure 2)

Mount jack to trailer tongue using only the hardware
provided in bag.
1. Insert 4 bolts through backing plates, 2 above and

2 below trailer tongue.

2. Attach mounting plate to bolts from opposite side of tongue.
3. Tighten securely with lock washers and nuts provided.
4. Check and re-tighten as needed.

WELDING INSTRUCTIONS (If Desired)

1. Locate jack as above.
2. Weld mounting plate to tongue using 5/32" minimum (4mm)

fillet weld all around perimeter of plate.

LUBRICATE GEARS (Figure 2)

1. Remove cap from top of jack.
2. Spoon in gear grease until gears are fully covered.
3. Replace cap. Periodically check grease if used frequently.

SWIVEL JACK UP OR DOWN (Figure 2)

1. Pull locking pin straight out to allow jack to swivel.
2. Swivel jack to desired position. Be certain pin snaps back into

locked position.

Swivel-Tongue Screw Jack

11127

Assembly and Installation Instructions
SAVE THESE INSTRUCTIONS

This product carries the standard Attwood one-year warranty.
See www.attwoodmarine.com or Product Catalog for details.

Form Number 69411 Rev. A

04-09

( 1 )

( 2 )

( 3 )

( 4 )

( 5 )

( 2 )

( 3 )

( 6 )

( 4 )

( 1 )

Figure 2

© 2004 Attwood Corporation
1016 N. Monroe Street, Lowell, MI 49331-0260 www.attwoodmarine.com

Figure 1

English

Français

Español

1

Bolt

Boulon

Perno

2

Wheel Fork

Fourche de roulette

Yugo de la rueda

3

Nylock Nut

Écrou de blocage
en nylon

Tuerca de seguridad

4

Bushing

Douille

Buje

English

Français

Español

1

Backing Plates

Plaques de support

Placas de respaldo

2

Retainer Ring

Anneau de rétention Anillo de retención

3

Mounting Plate

Plaque de montage

Placa de montaje

4

Cap

Capuchon

Tapa

5

Lock Washer & Nuts

Rondelle de blocage
et écrous

Arandela de presión
y tuerca

6

Locking Pin

Cheville de blocage

Horquilla de fijación