beautypg.com

Attwood Sportline Glove Boxes User Manual

Standard and sportline glove boxes, Glove box installation template, Bottom

background image

TOOLS REQUIRED FOR MOUNTING:

1. Drill and suitable bits
2. Six (6) #8 screws
3. Saber saw with appropriate saw blades
4. Prick-punch
5. Soft lead pencil

Standard and Sportline
Glove Boxes

2638, 2715, 2716
Installation Instructions

SAVE THESE INSTRUCTIONS
Form Number 69144 Rev. B

03-11

FEATURES:

Attwood glove boxes are specially designed for those who
enjoy a more sport-styled look. The Sportline glove box is a
matched companion to the Sportline steering wheel.

These glove boxes are made of rugged black plastic. The door
incorporates a marine locking latch. Located inside the door
are two drink holders that will help keep your beverages in
place when the door is open.

INSTALLATION INSTRUCTIONS:

1. Cut out glove box template.

2. With a soft lead pencil, blacken behind sheet compartment

hole cut line and the four corner saber saw cut drill holes.

3. Tape template in your desired location. Leave room for over-

all glove box dimensions as indicated on your template.

4. Mark the center of the four corner holes with prick-punch.

5. Drill 3/8" diameter starting holes and cut away on inside line.

6. Trace over compartment hole cut line connecting the four

3/8" diameter holes in each corner as shown and remove
template. Carefully saber saw along the cut line starting the
saw blade at one of the corner holes.

7. Install glove box and hold in position while marking the six

screw holes as indicated on illustration inside template.
Remove glove box.

8. Drill the six mounting screw holes where prick-punch marks

are located.

a. If wood or self-tapping screws are used, drill 1/8" diameter

hole into dash.

b. If screws with nuts are used, drill 3/16" diameter holes

through dash.

9. Install glove box into mounting hole and secure with #8

screws.

CAUTION:

Do not use acetone or other solvents on box or door.

© 2003 Attwood Corporation
1016 N. Monroe Street, Lowell, MI 49331-0260

www.attwoodmarine.com

(CUT & DETACH FROM INSTRUCTIONS)

TOP OF GLOVE BOX DOOR

TOP OF MOUNTING FLANGE

DRINK HOLDERS

1/2" FINGER ROOM

CUT LINE

CENTER LINE

MOUNTING HOLES

6 LOCATIONS

FOR LIGHT
IF REQUIRED

TOP

3/8" DIAMETER HOLE FOR
SABRE SAW (ALL FOUR CORNERS)

GLOVE BOX
INSTALLATION TEMPLATE

_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _

BOTTOM