Replacing bulb ss-a, Loosen the screw of the protector, Remove the protector – Canon E 333 D User Manual

Page 56: Attach the protector, Tighten the screw, Replacing bulb

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Replacing Bulb

Use only Canon Halogen Bulb MHL-5.7 V 4 W
(accessory).

• Before replacing the bulb, turn the power off

and allow sufficient time for the bulb to cool.

1. Loosen the screw of the protector.

2. Remove the protector.

3. Remove the old bulb and gentry

insert the new bulb as shown.

• Do not touch the new bulb with your bare

hands.

• If the bulb is dirty, wipe it with a soft, clean

cloth.

4. Attach the protector.

5. Tighten the screw.

Warning

Be careful not to touch the bulb during or
immediately after use; it becomes very hot.

Notes:

•

Keep the hot iamp away from flammable or plastic

materials.

• Protect the pop-up light from impact or vibration

during use or the halogen lamp may burn out.