Avl2 exposure compensation, Av0 exposure compensation – Canon 3000 V User Manual
Page 38
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Avl2 Exposure Compensation
Exposure compensation is used to alter the camera's standard
exposure setting. You can make the picture look lighter (increased
exposure) or darker (decreased exposure). The exposure
compensation amount can be set up to +/-2 stops in half-stop
increments.________________________________________________________
Turn the Mode Dial to a Creative
Zone mode except
Check the exposure setting.
• Press the shutter buttoh halfway
and check the display.
Set the exposure compensation
amount.
• Hold down the
turn the <^S^> dial.
• To cancel the exposure
compensation, set the exposure
compensation amount to .
Take the picture.
Standard exposure index
-2.1 ,».l .2*
I
Decreased
Increased
exposure
exposure
Exposure level mark
Q • The exposure compensation amount set is retained even after the
Mode Dial is set to <€9^>.
* The exposure compensation amount is canceled automatically
when you turn the Mode Dial to a Basic Zone mode.
• Assuming that a shutter speed of 1/125 sec. and an aperture
value of f/5.6 will give a correct exposure, setting the exposure
compensation amount to plus or minus 1 stop will change the
shutter speed or aperture value as follows;
“1 stop
0
+1 stop
Shutter speed
250
125
60
Aperture value
8.0
5.6
—>
4.0
38