Canon 3000 V - Manual (Page 22)

musing Red-eye Reduction
(with the built-in flash) ■
When flash is used in a low-light environment, the subject's eyes
may come out red in the photograph. To reduce this "Red eye" the
red-eye reduction lamp shines a light into the subject's eyes before
the flash is fired. Red-eye reduction works in all shooting modes
except <^> * •
Move the <►> arrow to the
<> icon on the LCD panel.
• Look at the LCD panel and press
the button to move the
arrow. (S6)
'
or
D
F
•
_| SB
1
1
^ Turn the <|S!> dial to set “ I ”
■“ on the LCD panel.
• Press the shutter button halfway to
return to normal camera operation.
• To cancel red-eye reduction, set
“ 0 ” on the LCD panel.
Red-eye reducttorr
tamp-m Indicetor
' When you press the Gutter bullon
halfway, the red-eye reduction lamp-on I
Indicator will appear in viewfindsr and
on the LCD panel.
' Red-eye reduction will not work urrless
Ihe subiect looks al the red-eye reduction
lamp. Tell the subject to ktok al the tamp.
■ For maximum effectiveness, press the shutter button fully after the
red-eye reduction lamp turns off (after 1.5 sec,).
' You can take a picture even while the red-eye reduction lamp is lit.
’ The effectiveness of red-eye reduction varies depending on the
subject.
> To further increase the effectiveness of red-eye reduction, go to a
brighter environment or move closer to the subject.
22