Canon 3000 V - Manual (Page 33)

4 Take the picture.
Compose the shot and press the
shutter button fully.
Ш
•ir30"” and the maximum aperture value blink, it
indicates underexposure. Use flash.
•If" ?0DD ” and the minimum aperture value blink, it
indicates overexposure. Use an ND filter to reduce
the light entering the lens.
The Difference Between and <0>
• The shutter speed and aperture value are set in the same way in
both modes.
• The following features can be used in the mode, but not in
the <0> mode.
Manual AF point selection
Film advance mode selection
Program shift
Exposure compensation
AEB
AE lock with the <■ )(■ > button
Multiple exposures
Built-in flash manual firing and
flash OFF
FE lock, high-speed sync
(with EX-sehes Speedlites)
About Program Shift
• In the Program AE mode, you can freely change the shutter speed
and aperture value combination (program) set by the camera while
retaining the same exposure. This is called program shift.
• To shift the program, press the shutter button halfway and turn the
<£Sa> dial until the desired shutter speed or aperture value is
displayed.
• Program shift is canceled automatically after the picture is taken.
• Program shift cannot be set when the built-in flash is used.
33