Canon IXUS Z70 - Manual (Page 46)

Setting and Adjusting the Date/Time
After changing the battery, or when traveling
internationally, it may be necessary to set or adjust the
camera’s date and time using the following procedure.
If “......... ” blinks on the LCD panel when you
change the battery, perform steps 2, 3, 4, and 6.
1
Press the Date button to
display the Date mode.
• The time is set in Date +
Time mode, step 5.
Seiect button Press the Select button.
• Use the push-button
projection on the strap
clasp
^ When you replace the
battery, the blinking
“------- " display changes to
"’98 1 r,
• The digits to be set start
blinking * •
Press the Set button.
• Use the push-button
projection on the strap
clasp.
• Press repeatedly until the
blinking digits show the
desired value.
Set button
B-46