Nikon 35MM Film Scanner LS-10E - Manual (Page 44)

[a]
Wt
OPEN
OPEN
mm:
PP:
[b]
Fig. 3.7 SCSI ID DIP switch settings of the rear of the
LS-10 Scanner
Position des interrupteurs DIP pour I’lD SCSI
à l’arrière du scanner LS-10
Einstellungen der SCSI-Adressen-DIP-
Schalter an der Rückseite des Scanners
LS-10
Setting the SCSI ID on the Internal
Scanner
The SCSI ID is set by a set of DIP switches on the back
of the internal-mount scanner as shown in Figure 3.7. In
most cases, these DIP switches wili not be changed.
[a] Typicaily reserved for computer
[b] Factory default for LS-10
If it is necessary to change the default SCSI ID, change
the position of the DIP switches to the proper SCSI ID as
shown in Figure 3.7. Use the Table 3.3. for proper DIP
Switch vaiues. When changing the position of the
switches, use a pointed instrument to toggle the switch.
It is not recommended to use a pencil or pen, since
these wiil color the switch and make it hard to
differentiate the “on” versus "off” position.
SCSI ID DIP #1 DIP #2 DIP #3
0 open Open open
1 closed open open
2 open closed open
3 closed closed open
4 open open closed
5 (ID) closed open closed
6 Open closed closed
7 closed closed closed
Table 3.3 SCSI ID DIP switch values.
SCSI ID 5 (ID) Indicates factory default.
44