Nikon N80 User Manual
Page 87
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
I Notes on using the optional Speedlight
• See your Speedlight manual for details. If the camera groups are defined in the
manual of the Speedlight with TTL auto flash, see the section for camera group I.
• Flash sync speed is 1/125 sec. or slower when using an optional Speedlight.
• Available film speeds for TTL auto flash are ISO 25 to ISO 1000.
• With the SB-26, 25 or 24, flash sync mode set on the Speedlight overrides the
setting on the camera body.
• When Red-Eye Reduction or Red-Eye Reduction with Slow Sync is set on a
camera attached with the SB-80DX, 28/28DX, 27 or 26, the Red-Eye
Reduction lamp of the Speedlight lights up.
• Even when the optional Speedlight with the AF-Assist Illuminator is attached,
AF-Assist Illuminator does not emit light unless the conditions for AF-Assist
Illumination are met (page 43).
• With SK-6 and SB-24 are attached, AF-Assist Illuminators of the camera body
and the Speedlight do not emit light.
• In Auto-Multi Program, the camera automatically controls the maximum
available aperture as follows in relation to the film speed:
ISO film speed
25
50
100
200
400
800
1000
Maximum
available
aperture
Built-in Speedlight
2
2.4
2.8
3.3
4
4.8
—
Optional Speedlight
2.8
3.3
4
4.8
5.6
6.7
6.7
* When film speed increases by one step, the maximum available aperture is
stopped down by 1/2 f/stop. If you are using a lens with a maximum aperture
smaller than that listed above, the automatically controlled aperture range is
from the lens' maximum to minimum aperture.
>
Use the optional Accessory Shoe Adaptor AS-15 to use the sync terminal
>
When flash exposure compensation is set, ® appears in the viewfinder
without the compensation value.
‘
fee
in the LCD panel and P in the viewfinder blink and the shutter cannot be
released when the exposure mode is set to P and attached Speedlight is not
set to TTL Auto Flash. Set the Speedlight flash mode to TTL, or set the
camera’s exposure mode to S, A or M.
>
To cancel Monitor Pre-Flash when using the SB-80DX, 50DX, 28/28DX, 27, 26
or 25, select Spot metering.
>
Using camera's built-in Speedlight and the SB-50DX, double-flash operation
and bounce-flash operation with double flash can be performed.
NOTE: Flash attachments made by manufacturers other than Nikon_____________
Use only Nikon Speedlights. Other units may damage the camera’s electrical
circuit due to incompatible voltage requirements (not compatible with 250V
or higher), electric contact alignment or switch phase.
87