Nikon N80 - Manual (Page 21)

IZI Check points
□ To change film speed with DX-coded film or select film advance mode,
see pages 36-37.
□ Shutter curtains are very thin. Do not touch the shutter curtains with
your finger or the film leader.
□ Avoid direct sunlight when changing film outdoors.
z
o
oc
UJ
Q.
o
o
m
3.3
3.4
Hold the film cartridge and ensure film is properly
positioned with no slack, then gently close the
camera back until the camera back snaps closed.
Film automatically advances to the first frame.
• When i appears on the LCD panel, the film has advanced to the first frame.
•When Err and E blink in the LCD panel and viewfinder, fiim is not
properiy installed. Open the camera back again and reioad film.
• QH and Err in the LCD panel and Err in viewfinder blink and the shutter
locks when a non-DX-coded film is loaded with camera film speed set to
IH. Set film speed manually (page 36).
• Frame number display remains when the power switch is off.
• You can check the number of avaiiabie exposures on the fiim roll through
the film cartridge confirmation window.
• Infrared films cannot be used since an infrared sensor is used for the
detection of the film frame position.
8: Camera can be set to advance the film to the first frame not until
the shutter release button is pressed (page 72).
Set the film advance mode selector to E] (single­
frame shooting) while pressing the film advance
mode selector lock release.
21