Nikon N80 - Manual (Page 36)

I
Film
[Setting and confirming fiim speed
Set the exposure mode/ISO film speed select dial to ISO
and rotate the Main-Command Dial to set film speed in use.
• Film speed can be set to DH and between ISO 6-6400 In 1/3 steps by rotating
the Main-Command Dial. When a film Is reinstalled, film speed is automatically
set to 10.
• When film speed is set to 10 and DX-coded film is installed, film speed Is
automatically set between ISO 25-5000. Film speed can also be set manually
with DX-coded film to have an effect of increased or decreased film sensitivity.
• Film speed can be set between ISO 6-6400 with non-DX-coded film.
• To confirm either automatically set or manually set film speed on the camera,
set the exposure mode/ISO film speed select dial to ISO.
• The shutter cannot be released when the exposure mode/ISO film speed
select dial is set to ISO. Set the dial to the desired exposure mode (P, S, A or
M) before shooting.
№ 1*11 Film speed setting can be set not to become (¡0 when a film is
reinstalled (page 71).
I Mid-roll rewind
To rewind film at mid-roll, press the two film rewind
buttons Qii simultaneously for approx. 1 sec.
36
• o.., o. and then o appear in the LCD panel and viewfinder during film rewind
and the frame counter counts backwards until rewind is complete.
• Film is completely rewound when the frame counter shows blinking (£
appears without blinking when the exposure meter is off.) Open the camera
back and remove the film cartridge. When the camera back is opened before
the film is completely rewound (before E blinks), warning indication (blinking
o. . and frame counter) appears in the LCD panel and viewfinder. Refer to
page 103 for troubleshooting.
tffTOi 13: High-speed film rewind is normally executed. This film rewind can be
changed to quiet film rewind (page 74).