Craftsman 139.53225SRT - Manual (Page 19)

installation Step 7
Imtatt the Light Bttd the Lem
Install the lights
- Install a 75 wait rruiximum light bulb in the scxtket.
The light will turn ON and remain lit for
approximately 4-1/2 minutes when power is
connected. Then the light will turn OFF.
• if the bulb bums out prematurely due to vibration,
replace i! with a standard neck "Garage Door
Opened* * bulb.
install the lens (excepi for Model 53225)
• Apply slight pressure on the sides of the Ittic, and
slide the tabs into the slots ¡n the end panel
• Reverse thé procedure to rerriove the lens.
Lem Gyitte
U§nt l*M:
Lew Star
7S W« Ma*.:
Uoht Bulb
Installation Step 8
Attach the Emergency Release
Rope and Handle
. emafgancy
Reieasif Handte
I
Do not use fhe red hanclie to pull the door
open or closed.
The rope knot coald become
untied and you could fall. Use the emergency
release only to disengage the trolley and. if
possible, only when the door is closed.
Garage doors are heavy. If the door is open
when
the handle is pulled, Ihe door could
close inadvertently if it is not properly
balanced. Serious injury may result to persons
under the door. Make sure the doorway is clear
of
persons and obstructions before pulling
handle when door is open.
• Thread one end of the rope through the hole in the
lop of the red handle so •NOTICE’ reads right side
up as shown. Secure with ao overhand knot.
The knot shoyld be at least
1
" from the end of the
rope tO: prevent slipping.
• Thread the other end of the rope through the hole in
the release arm of the outer trolley.
• Adjust rope length so the hanclie is 6 feet above fte
floor. Secure with a.n overhand knot
If it Is necessary to cut the rope, heat seal the cut
end with a match or lighter to prevent unraveling.
13