HP 2140 - Manual (Page 51)

LCD error messages
(continued)
Display Status/Solution
Memory Full
Press OK to continue
Memory has become full while scanning a document. Press OK
to send or copy the scanned pages only. To cancel the job press
Cancel and try again when memory becomes available, or split
the new document into smaller parts. See Clearing memory on
page 36.
Memory Received
Ink Low. Install new
ink cartridge
The machine has data stored in memory. Replace the print
cartridge with new one in order to print the faxes.
Memory Received
Load paper and
press OK
Load paper and press OK. There might be a jam. Clear the jam
as described in Paper jams during printing on page 41.
Memory Received
Install ink
cartridge
There is no print cartridge in the machine. Install a print cartridge.
No answer from
remote fax
The other machine has not answered after all redial attempts to
send a fax.
No CID Number The machine could not detect the CID (Caller ID) number.
No Dial Number There is no number in the redial memory.
Not available while
reprinting fax
The machine could not receive a new fax while printing the
stored faxes.
Not Found The number you are searching for does not exist in memory.
Number already
registered
The number you are trying to enter already exists in the phone
book or junk fax list.
Number Not Assigned There is no number assigned to this One-Touch or two-digit
Speed number.
Poll Code Error The remote user entered the wrong poll code.
Poll job exists
already
You have already programmed a polling send. Cancel scheduled
job and try again.
Polling Error
Check remote site
The machine you want to poll is not ready to answer your poll.
Check with the other person.
Receiving Error.
Ask sender to
try again.
There is an error while receiving a fax.
Remove j ammed
document
The document you are sending has jammed in the document
feeder. To clear the document jam, see Document jams during
transmission on page 41.
You tried to copy or fax a document which is longer than 390 mm
(15.4 in.).
Care and maintenance 47