Sony KV-32TS35 - Manual (Page 30)

1
Using the Pre-Programmed
Remote Commander
(
kv
-
zttssi
,
kv
-
zttsss
, m - mm , m - zmm .
You can operate other video equipment that has an infrared remote detector with this supplied Pre-Programmed Remote
Commander.
Operating Sony or non-Sony Video Equipment — Pre-Programmed Function
With the supplied Remote Commander, you can operate a Sony video
cassette recorder (Beta, 8mm, VHS) or multi disc player as well as most non-
Sony video equipment connected to your TV by following the steps below.
1 Set the TVA/TR selector to VTR.
TV VTR
c*
When the selector is set to VTR, the POWER and CH -i-/- buttons on the Remote
Commander function as video operating buttons and cannot be used to operate the TV.
2 While pressing CODE SET, press the 0 — 9 buttons to enter the
manufacturer’s code number (see chart on p. 31). For example, to
operate a Sony 8 mm VCR, press 0, 2 and ENTER.
CODE SET
+
ENTER
3 Use the video operating buttons on the Remote Commander to operate
the video equipment.
Operating a VCR
Press POWER
Press CH +/-
To turn on or off
To change channels
(when watching TV
programs through the
VCR’s tuner)
To record
To play
To stop
To fast forward
To rewind the tape
To pause
To search the picture
forward
and backward
Operating a Video Disc Player
Press • (2 buttons simultaneously).
Press ■.
Press
Press II.
Press ►► or during playback.
To play
To stop
To pause Press
To search the picture
fonward and backward
Press II.
To resume normal playback, press again.
•This function is effective only for CAV (standard-
play disc). With CLV (extended-play disc), the
TV will go into the standby mode if II is
pressed.
Keep pressing ►► or during playback.
To
resume normal playback, release the button.
30 Chapter 3: Advanced Operation