Battery life, To remove the battery pack, Notes on charging the battery pack – Sony CCD-TRV41 User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Battery life
Upper numbers are the time when recording with the viewfinder. Lower numbers art
the time when recording with the LCD screen. Using both will further reduce recordij
time.
CCD-TRV41
Battery pack
NP-F530
(supplied)
NP-F730
Continuous recording time*
120 (105)
90 (80)
270 (240)
200 (180)
Typical recording time**
70 (65)
55 (50)
160 (145)
120 (110)
Playing time on LCD
90 (80)
205 (185)
CCD-TRV81
Battery pack
NP-F530
(supplied)
NP-F730
Continuous recording-time*
115 (105)
75 (65)
265 (240)
170 (155)
Typical recording time**
70 (65)
45 (40)
160 (145)
100 (95)
Playing time on LCD
70(65)
170 (150)
Numbers in parentheses indicate the time when you use a normally charged battery.
Battery life will be shorter if you use the camcorder in a cold environment.
• Approximate continuous recording time indoors.
** Approximate minutes when recording while you repeat recording start/stop,
zooming and turning the power on/off. The actual battery life may be shorter.
Notes on remaining battery time indication during recording
• When you use the InfoLITHrUM battery pack, remaining battery time is displayed
the viewfinder or on the LCD screen. However, the indication may not be displayec
properly, depending on using conditions and circumstances.
• When you close the LCD panel and open it again, it takes about 2 minutes for the
correct remaining time to be displayed.
To remove the battery pack
Slide the battery pack in the direction of the arrow.
Notes on charging the battery pack
• The CHARGE lamp will remain lit for a while even if the battery pack is removed a
the power cord is unplugged after charging the battery pack. This is normal.
• If the CHARGE lamp does not light, discormect the power cord. After about one
minute, reconnect the power cord again.
• You cannot operate the camcorder using the AC power adaptor while charging the
battery pack.
• When a fully charged battery pack is installed, the CHARGE lamp will light once,
then go out.