Using alternative power sources, Using' th# house current, To remove the adaptor – Sony CCD-TRV41 User Manual
Page 22: Warning, Precaution, Notes on the vtr/camera lamp, Using the house current
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Using alternative power sources
Using' th# house current
(
1
)
Connect the AC power cord to a wall outlet.
(
2
)
Lift up the viewfinder.
(3)
Slide the connecting plate down into the guides at the rear of the camcorder
until it clicks.
To remove the adaptor
The adaptor is removed in the same way as the battery pack.
WARNING
The power cord must only be changed at a qualified service shop.
PRECAUTION
The set is not disconnected from the AC power source (mains) as long as it is connected
to the house current, even if the set itself has been turned off.
Notes on the VTR/CAMERA lamp
• The VTR/CAMERA lamp will remain lit for a while even if the unit is unplugged
after use. This is normal.
• If the VTR/CAMERA lamp does not light, disconnect the power cord. After about
one minute, reconnect the power cord.