To change the end point – Sony CCD-TRV41 User Manual
Page 61
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Replacing recording on a tape - Insert Editing
- CCD-TRV81 only
You can insert a new scene from a VCR onto your originailv recorded tape by
specifying starting and ending points.
Connections arc the same as in "Recording from a VCR or TV".
(1) While pressing the small green button on the POWER switch, set it to V'TR.
(
2
)
On the VCR, locate the start point to be inserted and set it to playback pause
mocie.
(3)
On the camcorder, locate the point where the insert should end bv pressing
or ►►, then press II to set it to playback pause mode.
(4) Press COUNTER RESET to set the counter to zero.
(5)
On the camcorder, locate the point where the insert should begin bv pressing
then press # REC and II to set it to recording pause mode.
(
6
)
Press ZERO MEM. The ZERO MEM indicator flashes and the end point of the
insert is stored in memory.
(7) Press II on the camcorder and the VCR simultaneously to start insert editing.
The insert editing stops automatically near the zero point on the counter.
To change the end point
Press ZERO MEM so that the ZERO MEM indicator disappears and begin from step 3.
Note on the inserted picture
The picture may be distorted at the end of the inserted portion when it is played back.