Sony CCD-FX410 - Manual (Page 27)

Chapter 3: Advanced Camera Operation
Connecting Alternative Power Sources
You can choose any of the following power sources for your camcorder: battery pack (see
page 7), house current, and 12/24 V car battery.
The appropriate power source for you to choose depends on the place where you want to
use your camcorder.
Place Power source Accessory to be used
Outdoors Battery pack Battery pack NP-55H (supplied). NP-77H/77HD.
NP-77, NP-66HorNP-55
Indoors House current AC power adaptor AC-V60A (supplied),
AC-V30 or AC-S10
In the car 12 V or 24 V car
battery
DC pack DCP-77
Note on power sources
Disconnecting the power source or removing the battery pack during recording or playback
may damage the inserted tape. In this case, supply the power again immediately.
Using House Curren
The supplied AC-V60A AC power adaptor is required.
1
2
3
Align the flat side of the connecting plate with the white line on the
camcorder, and push down and slide it in the direction of the arrow.
Connect the AC power adaptor to a wall outlet.
Set the CHARGE/VTR selector of the AC power adaptor to VTR.
See the instruction manual of the AC power adaptor for details.
To remove the connecting plate
Remove it in the same way as you do with the battery pack. See page 7.
Option AC-S10 AC power adaptor:
You can charge a battery, as well as discharge it to get the optimum condition of the
battery.
Advanced Camera Operation
27