Using the remote commander, Set power on the camcorder as follows – Sony CCD-FX410 User Manual

Page 22

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Using the Remote Commander

By using the Remote Commander, you can be in the picture with your friends and family,

or conveniently control the playback of your tape from a distance.

Insert two size AA (R6) batteries with
correct polarity.

Set m REMOTE COMMANDER

ON/OFF on the battery mounting
surface of the camcorder to ON.

If the battery is attached, remove it.
Reattach the battery after setting the
REMOTE COMMANDER ON/OFF switch.

Set POWER on the camcorder as follows:

— When camerarecording, 1) press the small green button on POWER and slide

POWER to CAMERA, 2) turn STANDBY up.

— When playing back, slide POWER to VTR.

Point the Commander to the remote sensor of the camcorder and press

the appropriate button on the Commander.

Remote sensor

2 m (6.6 ft)

(Approximate maximum distance and angles for remote control)

Note on the Remote Commander
• Keep the remote sensor away from the strong light source such as direct sunlight or

illumination. Remote control with the Commander may not be effective.

• The command mode of the Commander is VTR2. Avoid to use the Sony VCRs with the

same command mode at the same time.

Basic Camera Operation