Sony DHC-MD313 - Manual (Page 55)

A stereo FM programme is not received in
stereo.
• Press S rpKHt)/ MONO so "STEKHO"
appears,
if Other problems not described
above occur, reset the system as^
follows:
1 Unplug the mains lead.
2 Hold down POWER, then plug the mains
load into the wall outlet again.
The system is reset to the factory settings. All
the settings you made, such as the preset
stations, clock, and timer are cleared. You
should set them again.
Messages
One of the following messages may appear or
flash in the display window during operation.
MD
Auto cut
The MD deck is pausing the recording
because silence continued for 30 seconds or
more during digital recording.
Blank Disc
The inserted recordable MD is new or all
tracks on the MD have been erased.
Cannot Copy
You cannot make a digital recording (see
"Guide to the Serial Copy Management
System" on page 52).
Cannot edit
You tried to edit in Programme or Shuffle
Play mode.
Cannot REC
A pre-recorded MD is in the deck.
Disc Error
The inserted MD is damaged or does not
contain a TOC.
Impossible
You tried to combine from the first track on
an MD, which is not possible. You tried to
divide the first or enci of the track.
Level Over
,A strong signal was input during analog
recording in tile I .XPE function. Reduce the
recording level lollowing the procedure,
(see "IToubleshooting" on page ,54).
MD Disc Full
There is no time remaining on the disc (see
"System Limitations of MDs" on page 52).
MD NO DISC
There is no MD in the deck.
MD Protected
The inserted MD is protected against
Name Full
There is no more space to store track or
disc titles.
NEW
The MD deck stands by for recording on a
brand new MD or from the last recorded
portion.
No Name
The inserted MD has a track numbers but
no disc titles.
No Track
The inserted MD has a disc title but no
tracks.
OVER-
You have reached the end of the last track
during high-speed search.
Push STOP!
You pressed PLAY MODE during play.
Smart Space
The signal was input again after silence
continued for 30 seconds or less during
digital recording.
TOC Reading
The MD deck is reading the TOC
information of the MD.
TOC Writing
The MD deck is writing the information of
recorded or edited contents.
Track End
You have reached the end of the MD while
adjusting the division point during Divide
Function.
continued
55