Sony DHC-MD313 - Manual (Page 54)

Troubleshooting (continued)
CD Player
The CD tray does not close.
• The CD is not placed properly.
The CD will not eject.
• The CD has tape, seals, or paste on it.
The CD will not play.
•Press CD = to check the CD placed.
When you listening to the radio and the
disc tray is open, the CD indicator is lit
red, then the CD is not placed.
• The CD is dirty. Clean the CD with a
cleaning cloth.
•The face of the CD is scratched. Exchange
the CD.
• The CD is inserted label side down.
• Moisture condensation has built up.
Remov'e the CD and leave the system
turned on for about 2 hours until the
moisture evaporates.
Play does not start from the first track.
• The player is in programme or shuffle
mode. Press PLAY MODE repeatedly
until "SHUFFLE" or "PGM" disappears.
"OVER" is displayed.
• You have reached the end of the CD.
Press CD to return to the beginning
of the CD.
MD Deck
The controls do not work.
• The MD is dirty or scratched. ("Disc
Error" appears.) Replace the MD with a
new one.
54
The MD will not play.
• Moisture condensation has built up.
Remove the MD and leave the system
turned on for several hours until the
moisture evaporates.
• Insert the MD in the direction of the
arrow.
• Nothing is recorded on the MD.
Recording is not possible.
• The MD is protected against erasure.
("MD Protected" appears.) Slide the tab
to close the slot (see page 28).
•Connect the sound source properly.
• .-\ pre-recorded MD is in the deck.
Replace the disc with a recordable MD.
• Replace the di.sc with a recordable MD
that has sufficient time remaining or erase
unnecessary tracks.
• The mains lead was unplugged or a
power interruption occurrecl during
recording. Start recording over from the
beginning.
"END" is displayed.
• You have reached the end of the MD.
Press MD to return to the beginning
of the MD.
"Level Over" appears during analogue
recording.
A strong signal was input during
recording in the TAPE function. When
the sound is distorted, reduce the
recording level, then re-record. If
distortion may occurs:
1 Stop play or turn off the power of the
other component connected to the TAPE
input.
"Level Over" disappear.
2 Press EDIT on the remote during
recording or pause.
3 Press -r/- on the remote.
"Attenuate ?" appears.
4 Press ENTER/YES on the remote.
"Attenuate ON ?" appears.
5 Press ENTER/YES again.
"ATT" appears.
6 Turn on the power of the other
component connected to the TAPE input,
and continue recording or start recording’
over from the beginning.
Tuner * •
Severe hum or noise ("TUNED" or
"STEREO" flashes in the display.).
• Adjust the aerial.
• The signal strength is too weak. Connect
an external aerial.
• Make sure the aerial is connected
properly.
•You cannot fold or roll up the aerial.
•The FM aerial is split in two.
Repair or replace with a new one.
•The AM aerial is detached from the stand.