Sony DHC-MD313 - Manual (Page 33)

Marking track
numbers
When vou record from this system's CD
(digital recording), the track numbers are
automaticall)’ marked. In addition, vou can
mark track numbers:
• At any point while recording.
• Automatically while analog recording.
Marking track numbers at
a specific point while
recording
— Level-Synchro Recording
The "LEVEL-SYNC" is factory set to ON.
If "LEVEL-SYNC" disappears, do sfcp 1
through 5 to turn ON. Track numbers are
automatically marked when the input signal
is under a certain level for more than two
seconds and then exceed the previous level.
MD ; MD □
1 6
CEIDD0
iJt^O
S]OS
CSEGD
•;@OD
■|l — I n^jf I
1
Press
O
REC. The MD stands bv for
recording.
2
Press PLAY MODE until "PGM" or
"SHUFFLE" disappears.
3
Press EDIT then press + !
-
repeatedly until "LevelSync ?"
appears.
4
Press ENTER/YES.
"LevelSync ON ?" appears.
5
Press ENTER/YES again.
"LEVEL-SYNC" lights up.
6
Press MD ODD.
Recording starts.
To stop recording
Press MD □.
To cancel automatic track marking
1 Press EDIT during recording.
2 Press -r/- repeatedly until "LevelSync ?"
appears.
3 Press ENTER/YES.
"LevelSync OFF ?" appears.
4 Press ENTER/YES again.
"LEVEL-SYNC" disappears.
When "LEVEL-SYNC" disappears, a track
number is marked only at the beginning of
each recording.
Notes
• You may not mark track numbers auto matically if
the sound source to be recorded is noisy (e.g,.
tapes or radio programmes).
• The MD recording is complete only after all the
recording information is entered to TOC at which
point TOC stops flashing and goes out. Be careful
disconnect the mains lead or move the deck before
this point. Before disconnecting the mains lead, do
the following:
- Remove the MD.
- Press POWER, to turn off the system.
continued
33