beautypg.com

Caution, Installation verification, Warning – Tomei Powered METAL CATALYZER User Manual

Page 7: Emissions test

background image

3. Use the transmission bracket to temporarily lock the left and right cat in place.

4. Temporarily lock the metal cats and brackets into place.

5. Now fit the Transmission brackets and metal cats into place securely with care.
  Torque Specs for the supplied Nuts are [34.3~39.2N*m(3.5~4.0kgf-m)]

6. Install the rear O2 sensors in their correct positions.

Please take the time to double check that the sensors are connected to the correct positions

respectively.

7. When done then lastly connect the negative battery terminal.

CAUTION

* Make sure that all the bolts and parts are in the correct positions and nothing interferes with the
 chassis and body. When you cannot achieve adequate clearance with your vehicle due to any
 difference with the car and or manifold(s) then check all the bolts again after the initial run to
 re-adjust/correct any clearance and retighten all the bolts and nuts securely.

* Any oil or dirt that comes into contact with the Metal Cat. Converters can burn so please be careful.
After completing the install please be sure that the Metal Catalytic Converters are clean of any oil dirt
and/or grime.

INSTALLATION VERIFICATION

Check again that there is no interference with any parts.

Start the engine and let it idle first before taking it up to 2500 RPM to check and listen for any exhaust
leaks or signs of any abnormal sounds. Then recheck again for any exhaust leaks, abnormal sounds
for any loose parts etc.

WARNING

* Any interference with any parts/components can pose a fire risk hazard so please meticulously check
the car after the install.
* Any exhaust leaks can decrease performance efficiency and also pose a health risk hazard with toxic
exhaust gas poisoning.
* If there is anything felt abonormal when driving please stop immediately and check the car over.
* When any work or checks are to be done with the metal catalytic converters then do it when it is cold
to prevent burns.
* If any parts are lost or has fallen off then do not restart the car until the missing part(s) can be
replaced properly.

EMISSIONS TEST

* This “TOMEI Metal Catalytic Converter” comes with a copy of the emission test results certificate.
After the installation process of the new product, please keep your old stock parts in case you require
them in the future. The exhaust test records were performed in Japan with the product installed on a
stock standard vehicle that has been used on the street. The tests are to comply with the Japanese
road Truck Vehicle Laws, Section 31 emissions standards in Japan for “Smog, Foul smelling gas, toxic
gas and other emissions control equipment” This certificate may not be sufficient to comply with your
local public road regulations since each country has different laws and regulations but can also be used
as a reference for this product test results.
In addition this product will have an increase in vehicle operational noise which may not comply or meet
the Road Vehicles Act standards Section 30 “Anti-Noise Standards”. You may need to check to
confirm that this product complies with your local road use regulations.

7