Taylor-Wharton CS Series - Manual (Page 29)

27
CS SERIES
Installation & Setup
The CS SERIES Control System consists of the following components.
• Main Control
• VFD Display Module
• Wiring Harness Assembly
• Power Supply
• Thermocouple Assembly
• Lid Switch Assembly
• Sensor Assembly
• Cryogenic Solenoid Valve
• Remote Alarm Plug
• LN
2
• Plumbing
Connect the wiring harness assembly to the main control. The connector is keyed
and can only be plugged in one way.
Display Connector T/C #1 T/C #2
Main Harness Connector
Figure 11.0 Main Control Back Panel
Connect the thermocouple plug of the harness assembly into the control at the
thermocouple plug labeled T/C #1. One of the blades on the plug is slightly wider
insuring that it is plugged in correctly. The copper blade should plug into copper
colored plug. Finally, connect the display cable into the main control and the display.
Connection to Main Control
Figure 12.0 Connection to Main Control