Taylor-Wharton CS Series - Manual (Page 19)

17
CS SERIES
Control Setting Adjustments
Level
The standard sensor assembly that is installed on a freezer consists of a circuit
board with thermistors installed. The assembly has a maximum range of 6 inches
(150mm). Thermistor assignments can be changed through the menu system and
the operating range can be changed by either raising or lowering the circuit board
(offset) within the freezer.
If a wider range is needed between the start fill and stop fill thermistor, please
contact your supplier for an alternate sensor assembly.
Features & Settings
Some control settings can be changed through the menu system.
Enter and Exit the menu system by pressing:
Move down through the menu system by pressing:
Move up through the menu system by pressing:
Select a menu choice or lock in a setting by pressing:
Back out of the menu system by pressing:
When changing settings, single button presses will increment/decrement a value
one step at a time. Pressing and holding a button will allow for rapid change of a
setting.
The menu system incorporates icons to show the user settings which can be changed
and which are locked.
Locked menu choice:
Accessible menu choice:
Also, the menu system includes a scroll bar on the right side of the display. The
scroll bar will indicate the current location in the menu system and will indicate if
additional menu choices are available with the display of up and down arrows on
the scroll bar.
The control will continue to monitor all sensors and conditions while the user
accesses the menu system. If no activity is detected for 30 seconds, the control will
automatically return to the main operational screen.