Taylor-Wharton CS Series - Manual (Page 22)

20
CS SERIES
• Remote Alarm Delay: Allows the user to set the time before the remote
alarm relay is triggered after an error condition occurs. Settings [Immediate,
30, 60, 90 min] or [2,3, 4, 6 hours]
• Lid Open Alarm Delay: Allow the user to set the time before an alarm
condition occurs if the lid is opened too long.
• Valve Stuck Alarm: Allow the user to enable/disable this feature.
• Audible Re-trigger: Allows the user to set the time before the audible alarm
is re-triggered after an alarm has been acknowledged. Settings [15, 30, 60,
120, 240, 480 min] or [1 day]
– Display
• Display Brightness: Allows the user to adjust brightness for the display.
Settings [1 to 15]
• Screen Saver Time: Allows the user to adjust the time before the screen
saver starts working. Settings [0 to 60 min]
– Freezer ID: Allows the user the capability to change the freezer identification.
• SCHEDULED EVENTS
– Scheduled Fills
• Set Time: Allows the user to set the day and time for the next filling operation.
• Next Fill: Displays the next scheduled fill.
– LN
2
Supply Reminder
• Set Reminder: Allows the user to set the day which the control will display a
reminder to check the supply of LN
2
.
• Clear Reminder: Allows the user to acknowledge that the LN
2
supply has
been checked.
• Next Reminder: Displays the next scheduled reminder.
Below are the Menu Settings that are available only in the “Change
Settings” mode.
• SECURITY
– Settings Password: Allows the user to set a password to allow setting changes.
– Power Password: Allows the user to set the password which secures power
button operation.
• CONTACT SUPPORT
– Distributor: Contact information for the distributor.
– Taylor-Wharton: Contact information for Taylor-Wharton.
• SYSTEM INFORMATION
– Displays the control serial number, the firmware version and the freezer
identification.
Temperature
The temperature in the Cryostorage freezer is measured at the location of the
thermocouple. The installation location is different depending on the model of
the freezer but usually the thermocouple is positioned level with the top storage
box. This may mean that temperatures displayed may be slightly warmer than the
temperature experienced by the samples or product stored in the freezer.