Qmark ST - Commercial Slope Top Convectors - Manual

ST4X Series
Slope Top Convector
CAUTION - TO REDUCE RISK OF FIRE AND ELECTRIC
SHOCK OR INJURY TO PERSONS, OBSERVE THE
FOLLOWING:
1. Read all instructions carefully before using this heater. This
instruction sheet contains vital information for the proper
installation, use, and efficient operation of the heater.
Carefully read the manual before installation , operation or
cleaning of the heater. Failure to adhere to the instructions
could result in fire, electric shock, death, serious personal
injury, or property damage.
2. It is recommended that drapery be kept a minimum of four
(4”) inches from the top or front of heater.
3. This heater is not intended for residential use.
4. The heater is hot when in use. To avoid burns, do not let
bare skin touch hot surfaces.
5. A heater has hot and arcing or sparking parts inside. To
reduce the risk of fire, do not store or use gasoline or other
flammable vapors and liquids in the vicinity of the heater.
6. To prevent a possible fire, do not block air intakes or
exhaust in any manner. Do not use on soft surfaces, like a
bed, where openings may become blocked.
7. To reduce the possibility of electric shock, it is recommend-
ed the power to the heater be disconnected during wash
down.
8. Do not insert or allow foreign objects to enter any ventilation
or exhaust opening as this may cause an electric shock or
fire, or damage the heater.
9. Supply voltage must be the same as heater voltage. Check
heater nameplate and supply voltage before energizing.
10. Supply wiring must be rated minimum 75ºC. Use copper
wire only.
11. Use this heater only as described in this manual. Any other
use not recommended by the manufacturer may cause fire,
electric shock, or injury to persons.
SAVE THESE INSTRUCTIONS
!
WARNING
FILE # 0026740A.
Installation, Operation & Maintenance Instructions
GENERAL
The NEMA 4X Slope Top Convector is intended for installation in areas where periodic wash down with water is desired.
The enclosure is made of stainless steel to prevent corrosion and the wiring compartment meets NEMA 4X requirements for a water
tight construction.
CAUTION: To reduce the possibility for electric shock, it is recommended that the power to the heater be disconnected during wash
down.
IMPORTANT INSTRUCTIONS