Qmark EFQ Series - Commercial Fan-Forced Wall Heaters - Manual

Q Series
Commercial
Fan Forced
Wall Heaters
Read Carefully - These instructions are written to help you prevent
difficulties that might arise during installation of heaters. Studying
the instructions first may save you considerable time and money
later. Observe the following procedures and cut your installation
time to a minimum.
TO REDUCE RISK OF FIRE AND ELECTRIC SHOCK:
1. To prevent electrical shock, disconnect all power coming to
heater at main service panel before wiring or servicing.
2. All wiring must be in accordance with the National and Local
Electrical Codes and the heater must be grounded as a precau-
tion against possible electric shock.
3. Verify the power supply voltage coming to heater matches the
ratings printed on the heater nameplate before energizing.
4. This heater is hot when in use. To avoid burns, do not let bare
skin touch hot surfaces.
5. Do not insert or allow foreign objects to enter any ventilation or
exhaust opening as this may cause an electric shock, fire, or
damage to the heater.
6. To prevent a possible fire, do not block air intakes or exhaust in
any manner. Keep combustible materials, such as crates,
drapes, etc., away from heater. Do not install behind doors, furni-
ture, towels, or boxes. Do not install in ceiling.
7. Aheater has hot and arcing (sparking) parts inside. Do not use it
in areas where gasoline, paint, or flammable liquids are used or
stored.
8. Use this heater only as described in this manual. Any other use
not recommended by the manufacturer may cause fire, electric
shock, or injury to persons.
9. This heater is not approved for use in hazardous or corrosive
atmospheres, such as marine, green house, or chemical storage
areas.
WARNING
SAVE THESE INSTRUCTIONS
Installation & Maintenance Instructions
Dear Owner,
Congratulations! Thank you for purchasing this new heater manufactured by Marley Engineered
Products. You have made a wise investment selecting the highest quality product in the heating industry.
Please carefully read the installation and maintenance instructions shown in this manual. You should
enjoy years of efficient heating comfort with this product from Marley Engineered Products... the indus-
try’s leader in design, manufacturing, quality and service.
... The Employees of
Marley Engineered Products
1
!
31-3/4 (806mm)
Back box dimensions 30-3/8 (771mm) wide x 21-1/4 (540mm)
high x 3-3/4 (95mm) deep.
22-19/32
(565mm)