Qmark Artisan SmartSeries®- Architectural Digital Wall Heater - Manual

WHEN USING ELECTRIC APPLIANCES, BASIC PRECAU-
TIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE
RISK OF FIRE, ELECTRIC SHOCK, AND INJURY TO PER-
SONS, INCLUDING THE FOLLOWING:
1. Read all instructions before installing or using this heater.
2. This heater is hot when in use. To avoid burns, do not let
bare skin touch hot surfaces. Keep combustible materials,
such as furniture, pillows, bedding, papers, clothes, etc. and
curtains at least 3 feet (0.9 m) from the front of the heater.
3. Extreme caution is necessary when any heater is used by or
near children or invalids and whenever the heater is left
operating and unattended.
4. Do not operate any heater after it malfunctions. Disconnect
power at service panel and have heater inspected by a rep-
utable electrician before using.
5. Do not use outdoors.
6. To disconnect heater, turn controls to OFF, and turn OFF
power to heater circuit at main disconnect panel.
7. Do not insert or allow foreign objects to enter any ventilation
or exhaust opening as this may cause an electric shock, fire,
or damage to the heater.
8. To prevent a possible fire, do not block air intake or exhaust
in any manner.
9. A heater has hot and arcing or sparking parts inside. Do not
use it in areas where gasoline, paint, or flammable liquids
are used or stored.
10. Use this heater only as described in this manual. Any other
use not recommended by the manufacturer may cause fire,
electric shock, or injury to persons.
11. This heater is provided with a red alarm light that will illumi-
nate only if the heater has turned off as a result of over-
heating. Should the sensor register an overheat condition,
the heater will stop generating heat and the fan will turn off.
The red alarm light will turn ON, and ALL BUTTONS WILL
BE DISABLED. Once the heater is safe for resetting, the red
alarm light will blink/flash. DO NOT OPERATE THE
HEATER WITH THE ALARM LIGHT ILLUMINATED. See
TO RESET THERMAL LIMIT CONTROL in OPERATING
INSTRUCTIONS section.
12. This heater is intended for comfort heating applications and
not intended for use in special environments. Do not use in
damp or wet locations such as marine or greenhouse or in
areas where corrosive or chemical agents are present.
13. When installing, see INSTALLATION INSTRUCTIONS for
additional warnings and precautions.
14. For safe and efficient operation, and to extend the life of your
heater, keep your heater clean - See MAINTENANCE
INSTRUCTIONS.
SAVE THESE INSTRUCTIONS
!
Installation, Operation & Maintenance Instructions
WARNING
ECR 39603 11/12 5200-11074-001
IMPORTANT INSTRUCTIONS
ARWH Series
Smart Series
Architectural Wall Heater
MIN. SUPPLY
MODEL VOLTS PHASE WATTS AMPS WIRE GAUGE
ARWH1802 120 1 540-1800 15 12
ARWH4808 208 1 1440-4800 23.1 10
ARWH4804 240 1 1440-4800 20.0 10
ARWH4807 277 1 1440-4800 17.3 12
Table 1. Specifications
NOTE: The model numbers shown are Northern White color. Add suffix to the model number for the following colors:
AL = Aluminum, BZ = Bronze, W = Navajo White.