Qmark Open Coil Electric Duct Heaters - Manual

SAVE THESE INSTRUCTIONS
PPD 41026 04/14 5200-11205-000 (ISS 1.0)
Models FC, SC, FT, ST, RFC and RFT
Open Coil and Finned Tube Duct Heaters
WHEN USING ELECTRIC APPLIANCES, BASIC PRECAU-
TIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE
RISK OF FIRE, ELECTRIC SHOCK, AND INJURY TO PER-
SONS, INCLUDING THE FOLLOWING:
1. Do not operate without sufficient air flow. Insufficient airflow
could result in overheating and subsequent damage may
result.
2. DISCONNECT ALL POWER SOURCES before doing any
work on the heater installation.
3 Do not connect aluminum supply wires to a standard duct
heater. Order special line terminals that are suitable for
aluminum conductors and are properly sized for the larger
wire gauge they require.
4 Do not install standard heater outdoors. If heater will be
subect to weather, specify raintight construction.
5 Do not bundle, tie or wrap power wiring. This may cause
overheating and eventual breakdown of insulation.
!
Installation, Operation & Maintenance Instructions
WARNING
IMPORTANT INSTRUCTIONS
Open Coil Duct Heater Open Coil Duct Heater for round duct Finned Tube Duct Heater