beautypg.com

Qmark GFR Series - Fan-Forced Wall Heaters User Manual

R series b & t2 model, Save these instructions, Installation, operation & maintenance instructions

background image

1-3/4”

(44.5mm)

…

…

…

…

3-1/4”

(108mm)

13-7/8”

(352mm)

…

…

BACK

1-1/2”

(38mm)

…

…

…

…

4-1/4”

(108mm)

13-7/8”

(352mm)

…

…

…

…

7/8”

(22mm)

BOTTOM

…

16-7/8”

(429mm)

…

…

7-3/4”

(197mm)

…

FRONT

…

…

4-1/4”

(108mm)

1-1/8”

(29mm)

…

…

…

…

1-1/2”

(38mm)

(BACK)

SIDE

NOTE:

Knockouts in top

same dimensions

as bottom

R Series

B & T2 Model

Fan Forced Wall Heaters

WHEN USING ELECTRIC APPLIANCES, BASIC PRECAU-
TIONS SHOULD ALWAYS BE FOLLOWED TO REDUCE THE
RISK OF FIRE, ELECTRIC SHOCK, AND INJURY TO PER-
SONS, INCLUDING THE FOLLOWING:
1. Read all instructions before installing or using this heater.
2. This heater is hot when in use. To avoid burns, do not let

bare skin touch hot surfaces. Keep combustible materials,

such as furniture, pillows, bedding, papers, clothes, etc. and

curtains at least 3 feet (0.9 m) from the front of the heater.

3. Extreme caution is necessary when any heater is used by or

near children or invalids and whenever the heater is left

operating and unattended.

4. Do not operate any heater after it malfunctions. Disconnect

power at service panel and have heater inspected by a rep-

utable electrician before using.

5. Do not use outdoors.
6. To disconnect heater, turn controls to off, and turn off power

to heater circuit at main disconnect panel.

7. Do not insert or allow foreign objects to enter any ventilation

or exhaust opening as this may cause an electric shock, fire,

or damage to the heater.

8. To prevent a possible fire, do not block air intake or exhaust

in any manner.

9. A heater has hot and arcing or sparking parts inside. Do not

use it in areas where gasoline, paint, or flammable liquids

are used or stored.

10. Use this heater only as described in this manual. Any other

use not recommended by the manufacturer may cause fire,

electric shock, or injury to persons.

11. This heater is provided with a red alarm light that will illumi-

nate only if the heater has turned off as a result of over-

heating. If you see the light on, immediately turn the heater

off and inspect for any objects on or adjacent to the heater

that may have blocked the airflow or otherwise caused high

temperatures to have occurred.

DO NOT OPERATE THE

HEATER WITH THE ALARM LIGHT ILLUMINATING.

12. This heater is intended for comfort heating applications and

not intended for use in special environments. Do not use in

damp or wet locations such as marine or greenhouse or in

areas where corrosive or chemical agents are present.

13. When installing, see INSTALLATION INSTRUCTIONS for

additional warnings and precautions.

14. For safe and efficient operation, and to extend the life of your

heater, keep your heater clean - See MAINTENANCE

INSTRUCTIONS.

SAVE THESE INSTRUCTIONS

!

Installation, Operation & Maintenance Instructions

WARNING

IMPORTANT INSTRUCTIONS

PPD41511 6/14

5200-11214-000

1-3/4”

(44.5mm)

3-1/4”

(108mm)

13-7/8”

(352mm)

BACK

1-1/2”

(38mm)

4-1/4”

(108mm)

13-7/8”

(352mm)

7/8”

(22mm)

BOTTOM

16-7/8”

(429mm)

7-3/4”

(197mm)

FRONT

4-1/4”

(108mm)

1-1/8”

(29mm)

1-1/2”

(38mm)

(BACK)

SIDE

NOTE:

Knockouts in top

same dimensions

as bottom