Dell Compellent Series 30 - Manual (Page 48)

42 Storage Center System Setup Guide
Setting Up the Storage Center
Note For iSCSI only, servers initiate IO to iSCSI ports through the fault domain’s control
port. If an iSCSI port moves to a different fault domain, its control port will change.
This change will disrupt any service that was initiated through the previous control
port. If an iSCSI port moves to a different fault domain, you must reconfigure the
server-side iSCSI initiators before service can be resumed.
Figure 39. Fault Domain Properties (iSCSI)
4 Click OK to confirm any changes. The configuration is automatically validated. If the
validation is successful, the dialog shown in Figure 20 on page 27.

To edit a Virtual Port
Figure 40. Edit Virtual Ports (iSCSI)