Dell Compellent Series 30 - Manual (Page 44)

38 Storage Center System Setup Guide
Setting Up the Storage Center
Figure 33. Fault Domain Properties (Fibre Channel)
4 Click OK to confirm any changes. The configuration is automatically validated. If the
validation is successful, the window shown in Figure 30 on page 35 appears.
5 If there are no warnings, click Continue. If there are warnings, click Configure Local
Ports to modify the configuration and correct any issues that cause warnings. Refer to
Figure 31 on page 36.

To create a new fault domain
1 Click Create Fault Domain. The Create Fault Domain dialog appears.
Figure 34. Create Fault Domain (Fibre Channel)
2 Enter the name of the new domain, the type, and any additional notes. The following
window appears.