Step 7: system setup – Dell Compellent Series 30 User Manual

Page 23

Text mode
Original mode

Configuring a System via the Startup Wizard

Step 7: System Setup

The System Setup step allows you to set the System Name and Management IP
Address for the Storage Center.

Figure 11. System Setup

1 Enter the following:

•

Enter a System Name for the Storage Center.

•

(Dual-controller systems only) Enter the Management IP Address specified in
the pre-installation document. (On single-controller systems, this field is not
displayed and the message at the top of the dialog is slightly different.)

Note

The Management IP Address is distinct from the leader and peer controller
addresses. It is the address that manages a clustered-controller system. If the leader
or peer controller fails, the Management IP Address remains valid.

2 Click Continue. The dialog appears allowing you to enable or disable cache.