Adding and replacing parts – Dell Latitude X300 User Manual
Page 95
Adding and Replacing Parts
Adding Memory
You can increase your computer memory by installing a memory module on the system board. See "
Specifications
" for information on the memory supported by
your computer. Be sure to add only a memory module that is intended for your computer.
1.
Ensure that the work surface is flat and clean to prevent scratching the computer cover.
2.
Save and close any open files, exit any open programs, and shut down the computer.
3.
If the computer is connected to the media base (docked), undock it. See the documentation that came with your media base for instructions.
4.
Disconnect the computer from the electrical outlet.
5.
Wait 10 to 20 seconds, and then disconnect any attached devices.
6.
Remove any installed PC Cards and battery.
7.
Turn the computer over, unscrew both captive screw(s) from the memory module/Mini PCI/modem cover, and remove the cover.
8.
If you are replacing a memory module, remove the existing module.
a.
Use your fingertips to carefully spread apart the securing clips on each end of the memory module connector until the module pops up.
NOTE:
Memory modules purchased from Dell are covered under your computer warranty.
CAUTION:
Before working inside your computer, read the safety instructions in your System Information Guide.
NOTICE:
Handle components and cards by their edges, and avoid touching pins and contacts. Ground yourself by touching a metal connector on the
back of the computer. Continue to ground yourself periodically during this procedure.
1
captive screw (2)
2
cover
NOTICE:
To prevent damage to the memory module connector, do not use tools to spread the the memory module securing clips.
NOTICE:
Handle components and cards by their edges, and avoid touching pins and contacts. Ground yourself by touching a metal connector on the
back of the computer. Continue to ground yourself periodically during this procedure..