Dell PowerEdge 7250 User Manual
Page 21

SR870BN4 Error Reference Guide
BIOS POST Error Codes and Messages
Revision 1.0
15
Error Code
Error Message
Pause on Boot
Recommended User Action
8151
Processor 02: failed initialization
on last boot
Yes; user input required
Retest processor. If error
persists, hardware failure. User
should replace processor.
8152
Processor 03: failed initialization
on last boot
Yes; user input required
Retest processor. If error
persists, hardware failure. User
should replace processor.
8153
Processor 04: failed initialization
on last boot
Yes; user input required
Retest processor. If error
persists, hardware failure. User
should replace processor.
8180
BIOS does not support current
stepping for Processor 01
Yes
User should replace processor
with a supported stepping.
8181
BIOS does not support current
stepping for Processor 02
Yes
User should replace processor
with a supported stepping.
8182
BIOS does not support current
stepping for Processor 03
Yes
User should replace processor
with a supported stepping.
8183
BIOS does not support current
stepping for Processor 04
Yes
User should replace processor
with a supported stepping.
8193
CPUID, Processor Steppings are
different
Yes
Use processors with the same
stepping (e.g. C0, C1). User
information, typically n and n -1
stepping mixes allowed.
8194
CPUID, Processor Families are
different
Yes; user input required
Use processors that are the
same speed. CPUID has 3
fields=>stepping, family and
model. If any of the fields
mismatch, then user would get
this message. User has to
replace processor with the same
kind.
8196
Processor Models are Different
Yes; user input required
Use processors that are the
same speed and stepping.
8197
Processor Speed mismatch
Yes
Use processors that are the
same speed and stepping.
8300 Baseboard
Management
Controller failed to function
Yes
Try to reflash the BMC with the
most current version that is
compatible with your system
configuration. If problem
persists, may require board
replacement.
84F3 Baseboard
Management
Controller in Update Mode
Yes; user input required
The BMC recovery jumper is in
the active position and the BMC
can be reflashed. After
reflashing, move the jumper to
the inactive position.
84FF
System Event Log Full
Yes
Clear the SEL in BIOS setup.
8500
Multi-bit Error Detected Row1.
Row 1 mapped out
Yes
Verify the affected memory and
replace with correct memory.
8501
Multi-bit Error Detected Row2.
Row 2 mapped out
Yes
Verify the affected memory and
replace with correct memory.
8502
Multi-bit Error Detected Row3.
Row 3 mapped out
Yes
Verify the affected memory and
replace with correct memory.
8503
Multi-bit Error Detected Row4.
Row 4 mapped out
Yes
Verify the affected memory and
replace with correct memory.